Weidner Combi CM 3000
... built out of experience, made by professionals
for commercial use
You tell us how many wash guns you want to operate at the same time,
we dimension and tailor the right CM 3000 system for you, to suit your
cleaning needs.
The CM 3000 series is supposed, to be installed as a stationary unit
into an equipment room. The system can supply many drop stations and up
to 6 washing guns can be in operation at the same time. The systems are
used in all locations, where either only cold water is required or hot
water or steam is available.
Activating a simple push button sets the system into operation. The
SPS microprocessor controls and checks the correct operation of the
entire system.
The units are factory tested, which make the installation at site
very simple. After the connection of water and electricity and
connection to the piping system to the drop stations, the system is
ready to go.
|
CM 415
CM 423
|
Serial standard equipment.
- water holding tank is made from stainless steel with several
water inlet ball valves
- water level sensor
- safety temperatur control prevents pumping of to hot water
- booster pump to supply the high pressure pumps and prevent
cavitation
- automatic change of the starting pump ensures equal operation
hours
- pumps are automatic switched on and off, as requested
- total stop if pump is no longer needed
- safety stop if any hose bursts
- pumps are build on rubber elements to absorb vibrations
- hour meter for each pump aggregate
- stainless steel housing
- slow running triplex pumps with ceramic plungers
- direct drive between pump and motor, without pulleys and belts
- flexible coupling between motor and pump dampens torsion
moment
|
|
|
|
